
TalkTalk router set-up for Voipfone (Smartax mt882)
ok sorted, it randomly started working.
I had switched on business hours.. though for anyone with any problems on allowing port access with this modem follow these instructions...
Open up the smartax config page usually
http://192.168.1.1 and click the BASIC menu on the left .
Click the entry marked NAT
Select Redirect then click NEW
Select TCP
For the Local address enter the IP of your PC
Leave global addresses blank
Destination Port From needs to be 5004
Destination Port To needs to be 5060
Local port needs to be 5004
Click Submit
Now repeat but this time select UDP entering the same information and hit submit .
Once this is done click TOOLS from the left hand side and select SAVE & REBOOT .
Select SAVE and click submit .
Now click REBOOT and submit .